x
Menü

Bambu Lab PLA Aero Gray 1Kg Filament

1.576,68 TL
1.054,78 TL

Bamboo PLA Aero

Bambu PLA Aero achieves low density and light weight by foaming at high temperatures during printing, creating small holes in the print, making it ideal for lightweight, energy-efficient prints such as unmanned aerial vehicles (UAVs), aerodynamic models, and gliders.

 

Foamed PLA material (PLA Aero) has high requirements for material drying and parameter settings. Please read the instructions for printing aircraft models with foamed PLA (PLA Aero) carefully before starting the printing process .

PLA Aero
 

Low density and lightweight

Bambu PLA Aero has a similar filament density to regular PLA, but the build density is only 50%-80%.

 
PLA AeroRFID

*When printing a model of the same volume, PLA Aero is approximately half the weight of PLA Basic.

 

Controllable Model Density

By increasing the print temperature and decreasing the flow rate, the weight of the print is further reduced.

RFID
 

*The average print density will vary with changes in actual print temperature, flow ratio, print speed, model size, wall thickness, fill density and other parameters.

 
  Parameter Settings Average Density
Printing Temperature Increase ↗ Decrease↘
Print speed Increase ↗ Stable or increasing ↗
Flow Ratio Increase ↗ Increase ↗
Model size Increase ↗ Decrease↘
Wall thickness (wall loop) Increase ↗ Increase ↗
Packing Density Increase ↗ Increase ↗
 

Durable and impact resistant

Compared to pre-foamed wood PLA, Bambu PLA Aero and its prints are tougher and more resistant to impacts, bumps and drops.

 

 

 

Matte finish and can be painted

Bambu PLA Aero offers better dyeing results compared to PLA Basic and a matte surface texture that is easier to color.

RFID
 

Parameter Comparison

For a detailed comparison of different filaments, check out the Bambu Filament Guide >>

  PLA Basic PLA Aero
Printing Temperature 190-230℃ 210-260°C
Print speed < 300 mm/sec < 250 mm/sec
Flow Ratio 0.96 - 1 0.5–0.8
Filament Density 1.24g/cm3 1.21g/cm3
Foaming Speed / 0-120%
Print Density 1.21kg/m3 0.55-1.05kg/m3

 

Accessory Compatibility

  Recommendation Deprecated
Build Plate Ambient temperature plate, hot plate, textured PEI plate /
Hotend 0.4mm nozzle 0.6mm/0.8mm nozzle
seaweed Bamboo Liquid Glue
Stick
/
 

RFID for Intelligent Printing

All printing parameters are embedded in the RFID and can be read through the AMS (Automated Material System).

Just load and print! No more tedious setup steps required.

RFID
T-Soft E-Ticaret Sistemleriyle Hazırlanmıştır.